Our Repeating Stripes wallpaper, in a selection of neutral tones, is an easy way to add to movement and color to your space. As an accent wall or for an all-over room makeover, this design makes a statement but doesn't overwhelm.

• Paper substrate certified by Greenguard and to Forest Stewardship Council® standards.
• PVC-free renewable wood fiber-based substrate with water-activated adhesive backing.
• Each panel measures approximately 26"w x 11'h.
• Pre-pasted wallpaper.
• Requires water to activate glue. (See Details + Dimensions for instructions.)
• Strip from wall to remove.
• Rolls sold individually.
• Made in the USA.
• DETAILED SPECIFICATIONS Each roll measures approximately 26"w x 11'h and covers approximately 24'sq. of wall space.
• Rolls may be cut to size using an Exacto knife.
• To calculate the number of rolls you need: 1) Measure the height and the width of your space in inches; 2) Multiply the two numbers; 3) Divide the sum by 144; 4) Divide by coverage per roll (i.e. number of square feet covered per roll); 5) Multiply by 1.15 (to ensure sufficient supply for pattern alignment and potential mistakes); 6) Round up to the full roll.
• Can be applied over drywall, paint, paneling and to a wall previously covered with wallpaper (with adhesive removed).
• INSTALLATION Loosely roll the wallpaper with the printed side facing in.
• Completely submerge the rolled wallpaper in water (in a wallpaper tray) for 10 to 15 seconds to activate the adhesive.
• Slowly remove the roll by pulling the leading edge out of the tray, glue-side up.
• “Book” the wallpaper by laying it on the floor glue-side up; starting from the short ends of the wallpaper, fold either half of the glue side against itself for approximately 1 minute (avoid creasing).
• Unfold one half of the wallpaper, leaving the other half booked, and position the glue-exposed portion of the wallpaper on the wall.
• Once satisfied with the positioning, unfold the other half of the wallpaper to expose the remaining glue surface, and adhere to the wall.
• Working downward and outward, use a damp sponge to smooth and remove any excess glue.
• Tip: Do not over smooth. Bubbles smaller than the size of a quarter will dissipate as the wallpaper covering sets.